28 8.3 Spare And Wearing Parts; 28 8.4 Maintenance By The User; 28 8.4.1 Maintenance Agreement; 29 8.4.2 Maintenance Schedule - Beissbarth VLH 4440 Manual Original

8.3 Spare and wearing parts
Item/Component
Hydraulic fluid
(mineral fluid ISO 46, 5 litres)
8.4 Maintenance by the user
The maintenance work described below must be
performed by the user.
!
Prior to maintenance, the platform must always be
disconnected from the mains and secured to prevent
unauthorized use.
!
If components are damaged or worn or do not
function properly:
Inform Beissbarth customer service or an authorized
service agent.
8.4.1 Maintenance agreement
i
Regular upkeep of the lifting platform is essential to
ensure a long service life and permanent readiness
for use. We recommend concluding a maintenance
agreement with Beissbarth customer service or an
authorized service agent.
Beissbarth GmbH
8.4.2
Interval: T = Daily; W = Weekly; M = Monthly; 6M = Every
Order number
6 months; J = Annually; 6J = Every 6 years.
1 692 872 372
Component
T Stickers
T Drive-on ramps and
roll-off guards
T Wiring
T Hydraulic system
T Compressed air
service unit
T Detent pins
M Exposed surfaces
and edges
M Exposed surfaces
and edges
M Suspension cables
and pulleys
M Slack cable safety
system
M Cable break safety
system
M Foot protection
safety level
6M Hydraulic unit
6M Moving components Check lubrication:
6M Shear connectors
J Hydraulic unit
J Hydraulic unit
6J Hydraulic unit
Maintenance | VLH 4440 | 41
Maintenance schedule
Action
Visual inspection:
All stickers must be affixed and
clearly legible.
Visual inspection: Components must
not be damaged.
Visual inspection:
No damage to insulation.
Visual inspection:
No escape of fluid.
Drain condensate. Clean filter if
necessary. Check fluid level.
Functional test:
Detent pins must extend and retract
properly.
Cleaning:
Clean all contaminated surfaces
and apply preservative agent if
applicable.
Paintwork care:
Sand down paintwork blemishes
with sand paper (grain size 120)
and touch up with the appropriate
RAL shade.
Visual inspection:
Components must not be damaged
or worn.
Typical examples of cable damage:
Individual wire breaks, corrosion,
kinking, constriction, flattening,
looping, tangling.
Pay particular attention to cables in
area of threaded end pieces (under
end plate).
Functional test:
Actuate slack cable switch.
Functional test:
Check freedom of movement of
locking mechanism.
Functional test:
Raise the lifting platform and lower
it again.
Check fluid level in tank. Top up with
specified hydraulic fluid if necessary.
Lubricate all moving components
as per lubrication chart.
Check strength.
Tightening torque M12 = 60 Nm.
Re-tighten if necessary.
Change hydraulic fluid.
Only ever use organic hydraulic fluid.
Have hydraulic hoses checked by
VBG14.
Replace hydraulic hoses.
1 692 846 001
en
|
2017-04-27