Installing And Connecting - NAIM UNITIQUTE Guia De Inicio Rapido

UnitiQute Quick Start Guide

1 Installing and Connecting

• Stand UnitiQute on a stable surface and ensure it is well ventilated.
power
switch
left
speaker
mains input right
and fuse speaker
• C heck that the mains supply specified on the UnitiQute rear panel is appropriate for your
territory. Connect UnitiQute to the mains using the supplied cable but do not switch it on
until all other connections have been made.
dentify the signal Ground
• I
connected in a hi-fi system incorporating another earthed source component, or mains
hum is audible through the loudspeakers once UnitiQute is switched on.
• C onnect the left and right speakers to the speaker
when connecting the speakers that the positive and negative connection orientation at
both ends of the cable is the same for both channels.
• I f the UnitiQute daB/FM tuner is to be used, a suitable aerial must be connected to the
DAB/FM aerial socket. The DAB/FM tuner cannot operate without an aerial. Contact your
local Naim retailer or distributor for advice on selecting and installing an aerial.
• I f an external power amplifier or subwoofer is to be used, connect its signal cable to the
preamp output on the UnitiQute rear panel.
• I f any external audio sources are to be used with UnitiQute, connect these, using the
appropriate cables, to the front panel UsB socket or rear panel analogue or digital
inputs.
• I f an external digital to analogue converter, or an amplifier with a digital input, is to be
used with UnitiQute, connect it, using the appropriate cable, to the rear panel digital
output.
• I f UnitiQute is to play audio from a Upnp™ server or from an internet radio (iRadio)
station either its network
Ethernet cable or its Wi-Fi antenna must be fitted to the rear panel Wi-Fi socket. iradio
also requires a high-speed internet connection.
Full unitiQute installation and operational information can be found in the reference Manual
All manuals and user guides at all-guides.com
wireless network (Wi-Fi)
analogue
digital
input
output
preamp
output
signal
ground
switch
switch and select the "chassis" option unless UnitiQute is
outputs on the rear panel. Ensure
socket must be connected to a network router using an RJ45
available on line at www.naimaudio.com
antenna socket
DAB/FM
digital inputs aerial
1 & 3 (coaxial) socket
digital
inputs 2 & 4
RS232
network
(optical)
socket
socket
English
Note:
MP3 players
may be connected to
UnitiQute's front panel
analogue input using a
3.5mm stereo jack cable
from their headphone
sockets. Many Apple
iPod models may also
be connected to the
UnitiQute USB socket.