Steinbach Poolrunner Twin Manual Original página 31

Disconnecting the control unit
1. Disconnect the power plug from the
grounded socket.
2. Undo the screw fitting of the plug on the
control unit and pull of the floating cable
8
.
5
The control unit is disconnected.
Lifting the device out of the pool
1. Slowly pull the device by the floating cable
handle .
3
2. Slowly lift the device out of the water and hold it above the water surface.
After 10 to 15 seconds, most of the water that has collected in the housing has drained back into
the pool.
3. Set down the device next to the pool.
The device is lifted out of the pool.
Clean the device after each use to ensure continued trouble-free operation.
9
towards the water surface until you can reach the
5
8
5
31