Troy-Bilt Storm 2410 Manual Del Operador página 14

Auger Control
The auger control is located on the left handle. Squeeze the
control grip against the handle to engage the augers and start
snow throwing action. Release to stop.
Drive Control / Auger Clutch Lock
The drive control is located on the right handle. Squeeze the
control grip against the handle to engage the wheel drive.
Release to stop.
On select models, the drive control also locks the auger control
so that you can operate the chute directional control without
interrupting the snow throwing process. If the auger control is
engaged simultaneously with the drive control, the operator can
release the auger control (on the left handle) and the augers will
remain engaged. Release both controls to stop the augers and
wheel drive.
NOTE: Always release the drive control before changing speeds.
Failure to do so will result in increased wear on your machine's
drive system.
Heated Grips
(If so equipped)
CAUTION:
when using the heated grip. If the heated grip
becomes too hot, turn it off.
To activate the heated grips, move the switch found on the rear
of the dash panel into the ON position. To turn off the heated
grips, move the switch found on the rear of the dash panel to the
OFF position.
S 4 — C
14
ECTION ONTROLS AND
(If so equipped)
It is recommended that you wear gloves
F
EATURES
Standard Chute Directional Control
The chute directional control is located on left side of the snow
thrower. To change the direction in which snow is thrown, rotate
chute directional control.
2-Way Chute Directional Control
The 2-way chute directional control is located on the left side of
the dash panel.
To change the direction in which snow is thrown, squeeze
the button on the joy-stick and pivot the joy-stick to the
right or to the left.
(If so equipped)
T
(If so equipped)