Effervescence Operation (If Equipped); Chromatherapy Operation (If Equipped) - Kohler K-1110 Guía De Propietario

Neckjet and Backjet Operation (if equipped) (cont.)
To increase or decrease the flow volume to the neckjets, rotate the outer ring to the Flexjet mode,
press "OK" to activate the mode, and press either the up or down arrows on the keypad. This also
increases or decreases the flow to all modes.
Rotate the outer ring until the backjet icon is flashing and press "OK." The backjet pulsing action
will start at medium speed. The backjets pulse from the bottom of the whirlpool toward the top,
with water flow and pulse action occuring from two backjets at a time.
NOTE: If the water level falls below the water level sensors, the backjets will stop. The backjet icon and
indicator bar on the user keypad will flash. The backjets will automatically restart when the water level
covers the sensors.
To increase or decrease the backjet pulsing action, press either the up or down arrow buttons on the
keypad, while the backjet mode is active.
To increase or decrease the flow volume to the backjets, rotate the outer ring to the Flexjet mode,
press "OK" to activate the mode, and press either the up or down arrows on the keypad. This also
increases or decreases the flow to all modes.
NOTE: To activate or deactivate functions while the neckjets and/or backjets are operating, rotate the
outer ring until the desired function is flashing and press "OK." (Example: To turn the heater off, rotate the
outer ring until the heater icon is flashing and press "OK.")
Press "OK" while the neckjet mode is active, to turn off the neckjets.
Press "OK" while the backjet mode is active, to turn off the backjets.

Effervescence Operation (if equipped)

With the whirlpool operating, rotate the outer ring until the effervescence icon is flashing. Press
"OK" to activate the effervescence ports. The effervescence action will start at the flow volume last
set in the Flexjet flow mode.
Increase or decrease the flow volume by pressing either the up or down arrow buttons on the
keypad.
NOTE: The effervescence mode is intended to be a relaxing, soothing experience. The Flexjet mode,
backjets and neckjets will automatically turn off when the effervescence mode is activated. Chromatherapy
may be used with this and all modes of operation.
Press "OK" while the effervescence mode is flashing, to turn off the effervescence ports.

Chromatherapy Operation (if equipped)

NOTE: Chromatherapy may be used with all modes of operation. Chromatherapy may also be used when
the pump is not operating.
Chromatherapy Cycle - When this mode is activated, the chromatherapy lights will automatically
and continuously cycle through the eight colors; white, violet, indigo blue, aqua blue, green, yellow,
orange and red. One cycle through all eight colors takes approximately one minute. Rotate the outer
ring to select this mode and press "OK" to activate it. Press "OK" while the chromatherapy mode is
active, to turn off the lights.
Chromatherapy Specific Color Selection - When this mode is activated, you may choose a specific
color for the bath. Rotate the outer ring to select this mode, press "OK" to activate and use the
up/down arrows to reach the desired color. Press "OK" while the chromatherapy mode is active, to
turn off the lights.
1023260-5-B 6 Kohler Co.