Preparing For Operation; Unpacking The Instrument; Standalone Operation Or Installation In A 19" Rack - Rohde & Schwarz R&S SLG Manual De Instrucciones

R&S SLG
ASI INPUT A/B
Input for MPEG-2 transport stream.
ASI OUTPUT
Output for MPEG-2 transport stream.
10 MHz IN
Input for an external 10 MHz frequency reference.
L-BAND OUT
The 50 Ω SMA connector is the main RF output that covers a range of 250 to 3000
MHz. The 75 Ω F connector is a copy of the RF output degraded by the F connector
performance. The F connector can be used for DiSEqC protocol.

1.3 Preparing for Operation

The following section describes how to prepare the instrument for operation and how
to connect external devices. Please observe the general safety instructions for
operating the instrument.

1.3.1 Unpacking the Instrument

●
After unpacking the instrument, check the supplied equipment against the delivery
note to make sure all items are present.
●
Carefully check the instrument for possible damage.
●
Should there be any damage, please inform the carrier immediately. Keep the
packing material to support your claim.
●
The original packaging is also useful for transporting or shipping the instrument
later on.

1.3.2 Standalone Operation or Installation in a 19" Rack

The instrument is designed for interior use only. You can set it up as a standalone
device or install it in a 19" rack.
To install it in a 19" rack, you should install brackets on which the instrument can rest
before securing the ears of the front panel to the rack.
Getting Started 2116.9035.02 - 07
Putting the Instrument into Operation
Preparing for Operation
6