Safety Instructions; General Safety Instructions - Rohde & Schwarz R&S SLG Manual De Instrucciones

R&S SLG
Risk of material damage
Make sure that the following conditions are met at the operation site:
●
The ambient temperature does not exceed the range specified in the data sheet.
●
All fan openings are unobstructed and the airflow perforations are unimpeded. The
minimum distance from the wall is at least 10 cm.
Failure to meet these conditions may cause damage to the instrument or other devices
in the test setup.
If necessary, use proper protective equipment to protect devices against electrostatic
discharge in the event of human contact.

1.3.3 Safety Instructions

1.3.3.1

General Safety Instructions

Any noncompliance with these instructions can damage the instrument.
Prior to putting the instrument into operation, check the following:
●
The instrument cover is in place and screwed on.
●
Vent holes are not obstructed, and air flow is not blocked on the side panels. The
spacing from the wall should be at least 10 cm.
●
The signal levels at the inputs do not exceed permissible limits.
●
The outputs of the instrument are not overloaded or incorrectly connected.
●
In particular, please heed the maximum permissible reverse power allowed on the
RF outputs and ensure a DC voltage is not applied to the RF output.
●
The instrument may be operated only in a horizontal position, and the surface on
which it is placed must be level.
●
The ambient temperature must be in the range specified in chapter 6 of the User
Manual.
Getting Started 2116.9035.02 - 07
Putting the Instrument into Operation
Preparing for Operation
7