Operating The Unit; Operating Concept - Rohde & Schwarz R&S SLG Manual De Instrucciones

R&S SLG

3 Operating the Unit

3.1 Operating Concept

Getting Started
Modulator cable connections checklist:
●
AC power
●
L-BAND OUT connected to test equipment (e.g., spectrum analyzer, receiver,
video analyzer)
●
Control LAN connector connected to computer or network
●
All other connections are optional
When the unit is powered ON, default configuration is all carriers configured to CW at
minimum power. Transmit is OFF. If video or data is not being input, the unit is stuffing
the data stream with null packets. The Control LAN port can be used to monitor SLG
status and reconfigure it.
Factory Set IP Address
●
The factory defaults for the SLG network configuration are:
-
-
-
Once connection can be established with the SLG, network settings can be changed
via the web GUI. Consult your network administrator if you cannot connect to the SLG.
The SLG offers high flexibility in configuring a satellite frequency plan and as a result
has a large number of parameters to setup on the Inputs and Outputs page. The SLG
can be operated from a PC using the web GUI.
Getting Started 2116.9035.02 - 07
IP address = 192.168.10.1
Netmask = 255.255.255.0
Gateway = 192.168.10.1
Operating the Unit
Operating Concept
20