Charging Indications; Battery Charging Procedure; Work Area Temperature; Initial Assembly - CAMPAGNOLA EASY 80 Manual De Uso

4.2

Charging indications

Led lights
3 green led lights
2 green led lights
1 green led lights
1 red led light
Battery charger
Indication
Red
Green
4.3

Battery charging procedure

•
Charge the battery indoor.
•
Make sure the battery switch is in OFF position before charging.
•
Properly connect the charger to the battery.
•
Make sure the specifications of the battery and the charger are the right ones before charging.
•
The red led light on the charger indicates it is charging the battery, the green led light indicates that the battery is
fully charged. The average charging time is 4-5 hours.
•
Disconnect the charger when the battery is fully charged.
•
During periods of tool inactivity, store the battery fully charged and be sure to recharge it at least every 6 months.
4.4

Work area temperature

•
Recharging can be carried out only at a temperature between 0°C and + 45°C. The tool can be used only at a
temperature between -10°C and +60°C.
•
Keep the tool at a temperature between -5°C and +30°C when working
4.5

Initial assembly

Please check if pruner, cable and battery are all clean and dry.
Assemble as below steps:
•
Take out the backpack from the case.
•
Put the battery into the backpack.
•
Make sure there are no other people in the vicinity.
•
Connect the cable to the battery from the right side. By reversing the position of the battery in the backpack, it is
possible to choose the output direction of the cable and consequently the hand with which to use the tool,
depending on your preference.
•
Connect the cable to the tool
•
Wear the backpack and fasten its belt
•
Check that the blades are closed
•
Hold the shear handgrip tightly
Use and Maintenance Manual – Original
Instructions Rev.: 02, Date 22/07/2019
Lithium ions battery
Battery charge
80%-100%
50%-80%
30%-50%
< 30%
State
Charging
Full charge
Voltage
34 V <Vcc ≤ 42 V
Vcc ≤ 34 V
Page 31