Warning Tone Of The Battery; Troubleshooting - CAMPAGNOLA EASY 80 Manual De Uso

WARNING! If the battery is stored without being fully charged, the charging interval is reduced to 3 months.
WARNING!
If charging is not performed at the indicated intervals, the battery may deteriorate irreparably.
6.7

Warning tone of the battery

Warning
Duration
tone
1 tone 0.3 sec
2 tones 0.3 sec
3 tones 0.3 sec
4 tones 0.3 sec
4 short tones 0.1 sec
10 tones 0.3 sec
1 long tone 5 sec
6.8

Troubleshooting

WARNING!
The tool can be repaired just by qualified personnel of an Authorized Service Center, using original spare
parts only. This will ensure the tool safety and long life span.
Issue
The shear does not work
The mobile blade overheats
The cut is not smooth
The battery cannot get charged.
The red led light is flashing.
Use and Maintenance Manual – Original
Instructions Rev.: 02, Date 22/07/2019
Warning
Situation or Problem
frequency
No repetitions Tool switching on or off or change of the blade opening mode
The battery is charging or the shear is not connected well. Check if
10 repetitions
the nuts on the connectors are screwed tightly.
Fault of the Hall effect opening sensor. Send the shear to an
10 repetitions
Authorized Service Center.
Fault of the Hall effect opening sensor. Send the shear to an
10 repetitions
Authorized Service Center.
No repetitions The battery is flat. Recharge it.
The shear has carried out 100,000 cuts. Remove the front cover
10 repetitions
and grease the screw through the hole.
The shear has carried out 500,000 cuts. A thorough inspection and
10 repetitions
maintenance are necessary. Contact an Authorized service Center.
Possible cause
Wrong connection
Switch failure
Blunt blade
Damaged blade
Poor lubrication
Excessive friction on the blade
Dirty blade
Blunt blade
Wrong use of the shear
Flat battery
Battery not correctly connected
to its charger
Charger not correctly
connected to power
Dirty battery poles
Damaged battery
Damaged battery charger
Solution
Check the correct connection between the
tool and the battery.
Check that the switch is in position ON.
Send the shear to an Authorized Service
Point for repairing
Sharpen or replace the blade
Sharpen or replace the blade
Lubricate the blade
Lubricate the blade
Clean the blade
Sharpen or replace the blade
Read the instructions carefully
Charge the battery
Re-connect the battery to the charger
Re-connect the charger
Clean the poles
Replace the battery
Replace the battery charger
Page 35