Waterpik Sonic WP-860 Manual Del Usuario página 7

Prime Unit (First Time Use Only)
Set pressure control dial on base to high (pressure
setting No.10), point the handle and tip into sink.
Turn power and water ON until water flows from
the tip. Turn unit OFF.
ON
High
Adjusting the Pressure Setting
Turn the pressure control dial on the base of
the unit to the lowest setting (pressure setting
No.1) for first-time use.
Gradually increase
pressure over time to the
setting you prefer – or as
instructed by your dental
professional.
Using the Water Flosser
Always place the tip
in your mouth before
turning the water ON.
With water switch on
handle in OFF position, turn
power on. Lean over sink
and slightly close lips enough to
prevent splashing while still
allowing water to flow from
mouth into the sink.
Low
Water
ON
Turn water switch ON. When finished, turn
water switch and power OFF. During use you
can stop the flow of
water by sliding the water
switch on handle to the
OFF position.
NOTE: Motor will continue
to run.
Recommended Technique
For best results,
start with back teeth
and work toward the
front teeth. Direct the
stream at a 90-degree angle to your gumline with
tip in mouth. Glide tip along gumline and pause
briefly between teeth. Continue until you have
cleaned the inside and outside of both the upper
and lower teeth. Lean over sink.
When Finished
Turn the unit OFF. Empty any liquid left in the
reservoir. Unplug the unit.
NOTE: If you used mouthwash or other solution
besides water, see "Using Mouthwash and Other
Solutions" section.
7
Water
OFF