Reiner B6 Manual De Instrucciones página 5

GB
To set the stamp wheels  Fig.
A
Press the handle

travel, then while still holding it.
Press and hold button

A
Allow the handle

the handle locks in place.
You will be able to move the stamp wheels

D
freely with the stylus
You can hide preceding zeros in a number!
Example:
49
To do this move the stamp wheels

the adjusting pin
between "0" and "1".
In order to return to the print position,

simply push down on handle
Any wheel which has been put in 'non-print

position' will automatically be brought into
play as the numbering sequence progresses.
Wheels in 'non-print position' can also be
brought into play by simply rotating them
further (ie. push towards figure 1.).
To insert the inkpad  Fig.
Handle with caution to avoid dirt from ink!
A
Press the handle

travel, then while still holding it.
B
Press the button

continue to hold it pressed.
Allow the handle A

the handle locks in place.
Unpack the inkpad carefully.

1 2
+
to the bottom of its
B on the front plate.
to move upwards until
C
.
instead of 000049
D
with
C
to the empty spaces
A
.
1 3
+
to the bottom of its
on the front plate and
to move upwards until
Squeeze the grips

inkpad and hold them.
Resting the back of the ink pad inside the

pad cradle slide the pad into the slot
the stamp.
In order to return to the print position,

simply push down on handle
To change the numbering actions  Fig.
Actions
0 The same number is stamped every time.
1 Number increases after each stamping
process.
2 Number increases after every 2
stamping process.
etc.
Press the switch button

place it at the desired interval.
To park the stamp  Fig.
To prolong the life of the inkpad,
park the stamp!
Press and hold button

Gently push handle

stamp clicks & locks in a raised position.
In order to return to the print position,

simply push down on handle
GB
F
on the back of the
E
A
.
nd
G
downwards and
5
B
on the front plate.
A
downwards until the
A
.
of
4