Installing The Child Seat; General Information - Britax PIONEER Guia Del Usuario

Installing the Child Seat

General Information

Harness Mode
WARNING!
• Install forward-facing only.
• DO NOT use anything to raise the child seat off of the
vehicle seat.
• Do not install with the lower anchors for a child weighing
more than 45 lbs (20.4 kg).
• The top tether MUST be used in harness mode for
children that weigh more than 65 lbs (29.5 kg). BRITAX
recommends that the top tether be used at all times when
installing the child seat. Using the top tether will improve
the stability of your child seat and reduce the risk of injury.
• Use this child seat in harness
mode with children at least 2 years
of age and who weigh between
25 and 70 lbs (11.3 – 31.8 kg)
and who stand between 30 and
58 in. (76.2 – 147.3 cm) in height.
BRITAX recommends using
harness mode until your child
outgrows its fit requirements. See
the Child Seat Fit Requirements
section on page 6 for more
information.
• This seat may be used in either
the upright or recline position
in harness mode (see figures at
right).
8