Functional Description; Fuel Gauge - Milwaukee 48-59-1806 Manual Del Operador

FUNCTIONAL
DESCRIPTION
5
6
1. Contacts
2. Release buttons
3. Fuel Gauge button

4. Fuel Gauge

5. Electrical contacts
6. Bays
7. Vents
8. Cord
9. Skip button
10. Light indicators:
Continuous red: Charging
Continuous green light: Charging is complete
Fast flashing red: Battery is too hot/cold -
Charging will begin when battery
reaches correct charging
temperature
Slow flashing red: Battery charge is pending -
Charging will begin when the first
pack is fully charged
Flashing red/green: Damaged or faulty battery pack
SYMBOLOGY
Volts
Direct Current
Alternating Current
Double Insulated
Properly Recycle Batteries
Hertz
Amps
UL Listing for Canada and U.S.
10
9
SIX-PACK
CHARGER
Milwaukee Electric Tool Corp.
Brook eld, WI 53005 USA
7
1
2
4
3
SPECIFICATIONS
Cat. No. ............................................... 48-59-1806
Input Volts ....................................................120 AC
Input Amps....................................................2.1 AC
Output Volts .................................................. 18 DC
Output Amps ................................................ 3.5 DC
Recommended Ambient
Charging Temperature ................... 40°F to 105°F
M18™ Li-Ion Battery Packs ........................ 18 V DC
MILWAUKEE M18™
6
LI-ION BATTERY
Use the Fuel Gauge to deter
mine the battery pack's re-
maining run time. Press the
Fuel Gauge button to dis-
play the lights. The Fuel
8
Gauge will light up for 2-3
seconds. When less than
10% of charge is left, 1 light
on the fuel gauge will flash
slowly.
NOTE: If the Fuel Gauge doesn't appear to be
working, place the battery pack on the charger and
charge as needed.
Compared to NiCd battery pack types, MILWAUKEE
2
Li-Ion battery packs deliver fade-free power for their
entire run time. The tool will not experience a slow,
gradual loss of power as you work. To signal the
end of discharge, 1 light on the fuel gauge will flash
quickly for 2-3 seconds and the tool will not run.
Charge the battery pack.
NOTE: Immediately after using the battery pack,
the Fuel Gauge may display a lower charge than it
will if checked a few minutes later. The battery cells
"recover" some of their charge after resting.
Battery Pack Protection
To protect itself from damage and extend its life, the
battery pack's intelligent circuit monitors current draw
and temperature. In extremely high torque, binding,
stalling, and short circuit situations, the battery pack
will turn OFF the tool if the current draw becomes
too high. All the fuel gauge lights will flash. Release
the trigger and restart.
Under extreme circumstances, the internal tem-
perature of the battery could become too high. If
this happens, the fuel gauge lights will flash in an
alternating pattern and the tool will not run. Allow the
battery to cool down.
Fuel Gauge Lights
Lights 1 - 4 Solid
1 Light, flashing
slowly
1 Light, flashing
quickly
Lights 1-4, flashing
quickly
Lights 1&3 / 2&4,
flashing alternatingly
3
PACKS
Fuel Gauge
Approximate Run
Time Remaining
55-77
33-54 %
10-32 %
Less than 10% if bottom light
is flashing
Diagnosis Solution
Remaining run time Continue working
Less than 10% run
Prepare to charge pack
time left
End of discharge Charge pack
Current draw too Release trigger and
high restart, reduce pressure
Battery temperature Release trigger and allow
too high battery to cool
78-100 %
%