Problem And Solution - Domo DO216SV Manual De Instrucciones

CLEANING THE FLOOR BRUSH
1. Remove the floor nozzle from the upright vacuum cleaner. Press the
the back of the floor nozzle and remove it from the machine.
2. Open the release button on the left of the floor brush and click
to release the cover.
3. Remove the rotating floor brush from the floor nozzle.
4. Remove hairs and other dirt that have wrapped around the
floor brush. If you do not clean the floor brush regularly, it will
become damaged and your machine will become unusable.
5. The rotating floor brush may be rinsed off under running water. Make sure that it is
completely dry before using it.
6. Place the floor brush back into the floor nozzle when it is clean.
7. Click the closure valve back into place to close it. Close the release button.
8. Push the nozzle back onto the stick. The machine is now again ready for use.
Stuck hairs can damage the machine or your floor. Always remove the hairs stuck on the
brushes.

PROBLEM AND SOLUTION

Problem
The machine does not start up.
The machine does not vacuum.
The running time of the machine
is shorter and shorter.
www.domo-elektro.be
We advise replacing the filters regularly to
ensure an optimal operation of the machine.
Dirty filters will reduce the suction power
drastically. After every cleaning, clean the
dust reservoir and the filters to extend the
life span of your machine.
· The battery is empty. Charge the machine.
· The filters are dirty/the dust reservoir is full.
· The floor nozzle is clogged/the floor brush is blocked.
· Clean the machine as described in this manual.
· The machine is not sufficiently charged. Charge the
machine fully and try again.
· The battery is broken or old. Replace the battery.
· Stuck hairs.Remove the hairs stuck on the brushes.
release button at
Solution
25
DO216SV