Dyna-Glo DGB390BNP Manual De Instrucciones página 11

ASSEMBLY INSTRUCTIONS
10. Secure gas hose and hose holder (O)
assembly onto cart left side assembly (E) by
tightening 1 M4x12 screw (DD) and 1 M4 nut
(EE) into hole (labeled 1) into cart left side
table.
NOTE: The gas holder (O) must completely
encircle the gas hose before securing onto cart
left side panel (E) as illustrated below.
Hardware Used
DD M4x12 Screw
EE M4 Nut
11. Insert the grease pan (P) into position by
sliding it in the grill body from the rear along
the rails located just below the underside of
grill body.
NOTE: Grease pan MUST be in position as
illustrated below (grease cup support rails on
your left while facing the rear of the grill).
Insert grease cup (Q) into position by sliding
it onto the support rails on the bottom side of
grease pan.
10
DD
x 1
x 1
11
P
Q
11
1
O
E EE