Dyna-Glo DGB390BNP Manual De Instrucciones página 8

ASSEMBLY INSTRUCTIONS
3. Insert one M6x12 screw (AA) into each of the rear
holes of the cart left side panel and cart right
side panel (E & F), leaving 4-6mm clearance
from screw head to the side panels (E & F).
Attached the cart rear panel (G) by sliding
the keyholes in the cart rear panel over the
inserted screws and then push with force.
Secure the cart rear panel (G) to the bottom
shelf (A) with 2 M6x12 screws (AA). Tighten
the 2 screws on the side panels (E & F).
Hardware Used
AA M6x12 Screw
4. Insert 2 M6x12 screws (AA) into upper front holes
(labeled 1) in cart left side panel and right side
panel (E & F), leaving 4-6mm clearance from
screw head to left and right side panel (E & F).
Attach the upper front door brace (H) with the
larger hole in the upper front door brace (H),
slide the upper front door brace (H) so that
the screw head is over the smaller hole.
Secure the screws but do not tighten
completely. Secure another 2 M6x12 screws
into holes (labeled 2).
Hardware Used
AA M6x12 Screw
3
E
AA
x 4
4
H
1
x 4
8
G
AA
AA
F
2
E
AA
E