Dyna-Glo DGB390BNP Manual De Instrucciones página 17

OPERATION INSTRUCTIONS
Lighting The Grill
Before first use:
Remove all hangings or plastic straps, if present. Before you cook on your new gas grill, it is important
to clean your grill with heat. To do this, operate the grill for approximately 15 minutes with the lid closed
and the control knob in the highest position. This will clean the internal parts by burning off any residue
and odor from the manufacturing process.
If the flame extinguishes accidentally during ignition or operation, immediately TURN OFF the
cylinder valve and then TURN OFF the control knob.
Do not lean over grill when lighting. Read instructions before lighting.
1. Check that the control knobs are in the
2. Open valve at tank fully by turning
3. Open lid during lighting.
4. Push igniter down 3 to 4 seconds while turning right side control knob to the
burner should ignite.
5. Repeat for all other burners.
If ignition does not take place within 5 seconds, immediately turn the control knob to the
position. Wait 5 minutes and repeat step 4 above or refer to match lighting instructions below.
If the burner still does not light, check that there is gas in the cylinder and follow the match lighting
instructions.
CAUTION
WARNING
O
OFF position.
counter-clockwise.
17
HIGH position. The
O
OFF