Assembly Instructions - Dyna-Glo DGB390BNP Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

1. Assemble the casters, including 2 single
direction casters (V), 1 non-locking swivel
caster (C), 1 locking swivel caster (D), onto
bottom shelf (A) with 4 M6x12 screws (AA),
M6 plain washer (BB) and M6 spring washer
(CC) for each caster.
Hardware Used
AA
M6x12 Screw
M6 Plain
BB
Washer
M6 Spring
CC
Washer
2. Insert 4 M6x12 screws (AA) into holes in
bottom shelf (A), leaving 4-6mm clearance
from screw head to bottom shelf (A). Attached
cart left side panel (E) by placing the panel
keyholes over the screw heads on the left
side of bottom shelf (A), slide the cart left side
panel (E) so that the screw head is over the
smaller part of keyhole. Thread the screws
down snug but do not tighten completely at this
step. Repeat with cart right side panel (F).
Hardware Used
M6x12 Screw
AA
1
x 16
x 16
x 16
2
E
x 4
7
V
D
AA
CC
BB
F
E
C
A
A