Weight Unit Toggle Mode; Dimension Unit Toggle Mode - Snap-On EEWB333B Manual Del Operador

Figure 31b
Figure 31c
24

8.2 WEIGHT UNIT TOGGLE MODE

Setting the basic weight unit: oz/grams
Select this mode to change the unit of measure of the
weight before or after carrying out a balancing opera-
tion.
• Press the "MODE" key until the weight units indi-
cator fl ashes. The "oz" indicator will start fl ashing.
• The display will now look like Figure 31b.
• Press Return.
The weight setting status now calculates weights using
a different unit of measure (from grams to ounces or
from ounces to grams).
The program returns to the main menu.

8.3 DIMENSION UNIT TOGGLE MODE

Setting the basic unit of measure for diameter and
width: inches/mm
Select this mode to change the unit of measure of the
diameter and width before or after carrying out a bal-
ancing operation.
• Press the "MODE" key until the dimensional units
indicator blinks.
The "mm" indicator will start fl ashing.
The display should now appear as shown in Figure 31c.
Note: The operator can now select the units in steps
of 1 mm if the mm mode has been selected.
• Select return.
The state of the diameter and width dimension units
will toggle (inch to mm, or mm to inch).
Note: The unit is set to default to inches.
Offset is always measured and shown in millimeters.
The program returns to the main menu.
EEWB333B