Dimensions Of The Machine; Required Installation Area; Installation Instructions; Balancer Installation - Snap-On EEWB333B Manual Del Operador

PRE-INSTALLATION CONSIDERATIONS

1.7 DIMENSIONS OF THE MACHINE

Figure 4
Dimensions for the installation.

1.8 REQUIRED INSTALLATION AREA

Make sure that from the operating position the user
can see all of the machine and the surrounding area.
The operator should prevent non authorized persons
and/or objects from entering the area which may create
potential hazards.
The machine should be installed on a stable level fl oor.
Do not install the machine on a uneven fl oor.
If the balancer is to be installed on a raised fl oor, the
fl oor must have a capacity of at least 110lbs per sq ft.
(5000 N/m² - 500 kg/m²).
It is not required to secure the machine to the fl oor.
Install the machine in a dry, covered area.
The installation of the machine requires a working area
of at least 60" x 48" (1524mm x 1219 mm) (Figure 5).
NOTE: Do not install the balancer below grade level
or in a pit.
8
Figure 5
- Recommended Work Area

1.9 INSTALLATION INSTRUCTIONS

CAUTION! CAREFULLY REMOVE THE BALANCER
FROM THE PALLET.
Remove the hardware that secures the machine
to the pallet and slide the balancer onto the fl oor
where it is to be installed.
THE UNIT IS HEAVY AND THE WEIGHT IS NOT
EVENLY DISTRIBUTED.
DO NOT LIFT THE BALANCER BY THE SHAFT.
DROPPING THE UNIT MAY CAUSE PERSONAL
INJURY OR EQUIPMENT DAMAGE.
!!IMPORTANT!!!
Machines are shipped calibrated from the
factory. Do not attempt fi eld calibration
unless balance results deem calibration
as necessary.

2.0 BALANCER INSTALLATION

Mounting the Shaft Adapter
IMPORTANT!
CHECK THAT THE SURFACES ARE PERFECTLY
CLEAN AND NOT DAMAGED. AN INCORRECT MOUNT-
ING MAY RESULT IN SIGNIFICANT IMBALANCE.
A. (Figure 6)
Fit the Flange (A) and lock it with the bolts (B). Mount
the threaded shaft (C) onto the arbor of the balancer.
Tighten fi rmly, but do not exceed 70 inch-lbs.
EEWB333B
60"
48"