Inspection Before Measurement - Hioki 3280-10F Manual Del Usuario

Inspection Before Measurement

Inspection Before Measurement
• Verify that the instrument operates normally to
ensure that no damage occurred during storage
or shipping. If you find any damage, contact your
authorized Hioki distributor or reseller.
• If damage is suspected, check the section below
before contacting your authorized Hioki distributor
or reseller.
1
Check that the test lead is not broken.
Replace with the specified L9208 Test Lead.
2
Check that the resistance measurement and
continuity test operates normally.
Have the instrument repaired by the your
authorized Hioki distributor or reseller. The
instrument may have been subject to a voltage
of greater than 600 V during resistance
measurement or continuity testing.
3
Check that the battery voltage is not low.
Replace the batteries.
EN-8
HIOKI 3280H980-01