Taking A Measurement - Microlife BP3GR1-3P Manual De Instruccion

5.4. Taking a measurement

After the cuff has been appropriately
positioned the measurement can begin.
Remain still during your measurement, do
not flex muscles.
a) Remain seated quietly for 5 minutes
before you begin the measurement.
b) Press the POWER button. After the system
check, the monitor displays OK and the
pump begins to inflate the cuff. On the
display, the increasing cuff pressure is
continually shown.
c) After automatically reaching an individ-
ual pressure, the pump stops and the
pressure slowly falls. The cuff pressure
is displayed during the measurement.
d) When the device has detected your
pulse, the heart symbol in the display
begins to blink.
e) When the measurement has been
concluded, the air will automatically
release from the cuff. The measured
systolic and diastolic blood pressure
values, as well as the pulse, are now
displayed.
f) The measurement results are displayed
until you switch the device off. If no
button is pressed for 1 minute, the
device switches off automatically.
18
Pumping
Pressure
Measuring
Measurement Complete
Systolic
Diastolic
Pulse