Blade Assembly; Final Fan Assembly - Craftmade Anillo ANI36 Guia De Instalacion

8. Blade Assembly.

WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and
break.
Time Saver: Washers for blade screws can
be set on each blade screw prior to
installing blades.
Locate 9 blade attachment screws and
washers in hardware pack. Slide blade
through one of the narrow, rectangular
openings on motor assembly, aligning
holes in blade with holes in blade arm
(located on the underside of the motor
assembly)--refer to drawing at right. Insert
3 blade attachment screws (along with
washers) with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for each
remaining blade.
NOTE: Tighten blade arm screws twice a
year.

9. Final Fan Assembly.

Remove 1 screw from motor plate on
underside of motor assembly and
partially loosen the other 2 screws.
Align slotted holes in fitter plate
(please note side of fitter plate with
label indicating THIS SIDE UP) with
loosened screws in motor plate. Twist
fitter plate to lock. Re-insert screw
that was previously removed and
securely tighten all 3 screws with a
Phillips screwdriver.
Align 3 posts inside shade with the
rounded part of the slot on outside
edge of fitter plate. Turn shade to the
RIGHT (clockwise) until it no longer
turns.
NOTE: Make sure to turn shade all the
way to secure completely.
blade arm
page 7
motor assembly
blade
blade attachment
screws and washers
motor assembly
motor plate
fitter plate
motor assembly
fitter plate
shade