Operating Sequence; Modes Of Operation - Kohler K-1111-VLN Guia De Instalacion

Activates Mode
Selected
Backjet Mode-
Adjust Pulse
Rotate outer
ring to access
desired mode.
Chromatherapy-
Specific Color
Lighted User Keypad

14. Operating Sequence

Your whirlpool is equipped with two keypads, each controlled by its own operating system. Follow the steps
below to confirm the keypads are operating correctly.
NOTE: A built-in heater automatically helps to maintain the water temperature when the whirlpool is
running, as long as the water temperature does not exceed 104°F (40°C). The heater will disengage at
higher temperatures.
IMPORTANT! Please refer to your Homeowners Guide for detailed instructions on the user keypad and
remote control.
NOTE: The keypad controls the chromatherapy feature.
Press the Power On/Off button on the keypad to turn the whirlpool on. The whirlpool will start at
medium flow and three small lights near the whirlpool floor will illuminate as long as the keypad
remains lit.
Increase or decrease the water flow by pressing either the up or down arrow buttons on the keypad.
An indicator bar in the center of the keypad shows the water flow volume.
Adjust each Flexjet for optimum air/water mixture. Turn the Flexjet trim clockwise to reduce the air
flow and counterclockwise to increase the airflow.
Rotate the outer ring until the heater button is flashing. Press "OK" to turn the heater off. Press
"OK" again to turn the heater back on. The heater will help to maintain the water temperature up to
104°F (40°C).
Press the Power On/Off button a second time to turn the whirlpool off. The lights near the
whirlpool floor will remain illuminated until the keypad enters the sleep mode.
Repeat the steps above to verify the operation of the second keypad.
NOTE: A built-in timer automatically stops the pump and motor after approximately 20 minutes of
operation.

15. Modes of Operation

Backjet Operation
Rotate the outer ring until the backjet mode is flashing and press "OK". The backjet pulsing action
will start at medium speed. The backjet pulsing action will start at medium speed. The backjets
pulse from the bottom of the whirlpool toward the top, with water flow and pulse action occuring
from two backjets at a time.
1042760-2-C
Flexjet Flow Mode
Power
On/Off
Heater
On/Off
Increases Flow
or Pulse Rate
Effervescence
Mode
Indicator Bar - Shows
water flow volume or
pulse rate
Chromatherapy
Cycle
Decreases
Flow
14
Turn the Flexjet
trim clockwise to
decrease the flow.
Turn the Flexjet trim
counterclockwise to
increase the flow.
Kohler Co.