Important Information; Product Information; Electrical Requirements; Product Notices - Kohler K-1111-VLN Guia De Instalacion

Important Information

WARNING: When using electrical products, basic precautions should always be followed,
including the following:
DANGER: Risk of electric shock. Connect only to circuits protected by Ground-Fault
Circuit-Interrupters (GFCI's) or Earth-Leakage Circuit-Breakers (ELCB's).
WARNING: Risk of electric shock. A licensed electrician should make all electrical connections.
WARNING: Risk of electric shock. Disconnect power before servicing.
WARNING: Risk of injury or property damage. Please read all instructions thoroughly before
beginning installation, including the following requirements.
Building materials and wiring should be routed away from the pump bodies and other heat-producing
components of the unit.
Install to permit access for servicing.
Pressure wire connectors marked "Earth/Ground" are provided within the wiring compartments. To reduce
the risk of electric shock, connect these connectors to the grounding terminals of your electric service or
supply panel with copper wire equivalent in size to the circuit conductors supplying this equipment.
Pressure wire connectors are provided on the exterior of the junction boxes or controls within this unit to
permit connection of bonding conductors between this unit and all other exposed metal in the vicinity, as
needed to comply with local requirements.
Grounding is required. The unit should be installed by a qualified service representative, and grounded.
NOTICE: Follow all local plumbing and electrical codes.

Product Information

Electrical Requirements

The installation must have two Class A Ground-Fault Circuit-Interrupters (GFCI's) or Earth-Leakage
Circuit-Breakers (ELCB's). The GFCI's or ELCB's protect against line-to-ground shock hazard. Use two
220-240 V, 20 A, 50/60 Hz dedicated services; one for each pump/control/heater system.

Product Notices

WARNING: Unauthorized modification may cause unsafe operation and poor performance of the
whirlpool. Do not relocate the whirlpool pumps, or make other modifications to the whirlpool
system, as this could adversely affect the performance and safe operation of the whirlpool. Kohler
Co. shall not be liable under its warranty or otherwise for personal injury or damage caused by any
such unauthorized modification.

Features

Components include two pumps, two controls, two heaters, 6 Flexjets, 20 Bodyssage backjets, 8 effervescence
ports, 4 chromatherapy lights, 2 pillows, and two illuminated keypads with two remote controls.

Connections and Service Access

Before installation, ensure proper access to the final connections.
NOTICE: Provide generous, unrestricted service access to the pumps. You must provide a minimum of
three 34" (86.4 cm) wide x 15" (38.1 cm) high access panels for servicing the pumps and controls. The
access must be located immediately next to the pumps. Study the roughing-in information packed with the
1042760-2-C 2 Kohler Co.