Remote Control Operation - Kohler K-1111-VLN Guia De Instalacion

Modes of Operation (cont.)
NOTE: If the water level falls below the water level sensors, the backjets will stop. The backjet icon and
indicator bar on the user keypad will flash. The backjets will automatically restart when the water level
covers the sensors.
To increase or decrease the backjet pulsing action, press either the up or down arrow buttons on the
keypad, while the backjet mode is active.
To increase or decrease the flow volume to the backjets, rotate the outer ring to the Flexjet mode,
press "OK" to activate the mode, and press either the up or down arrows on the keypad. This also
increases or decreases the flow to all modes.
NOTE: To activate or deactivate different modes while the backjets are operating, rotate the outer ring
until the disired mode is flashing and press "OK". (Example: To turn the heater off, rotate the ring until the
heater icon is flashing and press "OK").
Press "OK" while the backjet mode is flashing to turn off the backjets.
Repeat the above steps for the second keypad.
Effervescence Operation
With the whirlpool operating, rotate the outer ring of the keypad until the effervescence icon is
flashing.
Press "OK" to activate the effervescence ports. The effervescence action will start at the flow volume
last set in the flexjet flow mode.
Increase or decrease the flow volume by pressing either the up or down arrow buttons on the
keypad.
NOTE: The effervescence mode is intended to be a relaxing, soothing experience. The Flexjet mode and
backjets will automatically turn off when the effervescence mode is activated. Chromatherapy may be used
with all modes of operation.
Press "OK" while the effervescence mode is flashing to turn off the effervescence ports.
Repeat the above steps for the second keypad.
Chromatherapy Operation
NOTE: Chromatherapy may be used with all modes of operation or when the pump is not operating.
When the pump is not operating, only one of the keypads will control the chromatherapy operation.
Chromatherapy Cycle. When this mode is activated, the chromatherapy lights will automatically
and continuously cycle through the eight colors; white, violet, indigo blue, aqua blue, green, yellow,
orange, and red. One cycle through all eight colors takes approximately one minute. Rotate the
outer ring to select this mode and press "OK" to activate it. Press "OK" while the chromatherapy
mode is active to end the cycle.
Chromatherapy Specific Color Selection. When this mode is activated, you may choose a specific
color for the bath. Rotate the outer ring to select this mode and press "OK" to activate it. Use the
up/down arrows to reach the desired color. Press "OK" while the chromatherapy mode is active to
end the Chromatherapy operation.

16. Remote Control Operation

NOTE: Refer to your Homeowners Guide for detailed instructions on your remote control.
Because your unit has two keypads and two remote controls, you must program both remote
controls. For detailed instructions, refer to the supplemental instruction sheet, "Programming Your
Remote Controls", packed with your literature.
The remote control places the whirlpool functions at your fingertips. You may access and modify all
modes/features from the remote control. The waterproof remote control is designed to be used in
the bath and will float in the water. The remote control uses two AAA batteries.
Kohler Co. 15 1042760-2-C