Child Seat Functions; Adjusting The Harness Height; Adjusting The Buckle Position - Britax ROUNDABOUT 55 Guia Del Usuario

Child Seat Functions

Adjusting the Harness Height

NOTE: In rear-facing mode,
always position the harness straps
at or below your child's shoulders.
See page 5.
In forward-facing mode, always
position the harness straps at or
above your child's shoulders. See
page 5.
Loosen the harness.
1
a Lift harness adjuster lever
b Pull both harness straps forward
Unhook both harness straps
2
from the yoke.
Pull one harness strap through
3
the shell and cover to the front
of the child seat.
Feed the harness strap
4
through the desired harness
slot in the cover and shell to
the back of the child seat.
Repeat steps 3 and 4 for
second harness strap.
Nest the harness straps by
5
inserting the right strap loop
into the left strap loop.
Before reattaching the harness
6
straps to the yoke, hold the
harness yoke as shown, and
ensure that the adjuster strap
attached to the yoke is not
twisted.
Slide nested harness straps
7
completely onto the harness
yoke.
12
1b
1a
2 2
3 3
4 4
5 5
6
7
Adjuster
Strap

Adjusting the Buckle Position

IMPORTANT:
• ALWAYS position the buckle in the
inner slot for rear-facing use when
using a vehicle seat belt installation.
• The vehicle belt must pass in front of
the buckle strap for rear-facing use.
• Position the buckle in the slot closest
to but not under the child for rear-facing use when using the
LATCH installation.
• NEVER leave the buckle in the adjustment slot.
• Use the outer buckle slot when installing the child seat forward-
facing with a child weighing 13.6 kg (30 lbs) and above or if the
buckle is under the child in the inner position.
1 Unbuckle the harness.
Remove the belly pad and
push the buckle through the
cover.
2 Turn the buckle webbing
and slide it between buckle
positions.
3 Slide the buckle retainer into
the buckle slot, and ensure
the red release button faces
out.
Child Seat Functions
ADJUSTMENT
SLOT
13