Child Seat Functions; Adjusting The Harness Height; Adjusting The Buckle Position - Britax MARATHON 70-G3 Guia Del Usuario

Child Seat Functions

Adjusting the Harness Height

Loosen the harness.
1
a Lift harness adjuster lever
b Pull both harness straps forward
Squeeze the harness height
2
adjuster, slide the harness
into the desired position and
release.
* Ensure the harness has locked
into position.
NOTE: In rear-facing mode, always position the harness straps at
or below your child's shoulders. See page 5.
In forward-facing mode, always position the harness straps at or
above your child's shoulders. See page 5.
12
1b
1a

Adjusting the Buckle Position

IMPORTANT:
• ALWAYS position the buckle in the
inner slot for rear-facing use when
using a vehicle seat belt installation.
• The vehicle belt must pass in front of
the buckle strap for rear-facing use.
• Position the buckle in the slot closest
to but not under the child for rear-facing use when using the
LATCH installation.
• NEVER leave the buckle in the adjustment slot.
• Use the outer buckle slot when installing the child seat forward-
facing with a child weighing 13.6 kg (30 lbs) and above or if the
buckle is under the child in the inner position.
1 Unbuckle the harness. Remove
the belly pad and buckle. See
page 38, steps 1a - 1d.
2 Route the belly pad and buckle
through the desired slot in the
cover.
* Slide the end of the belly pad
under the comfort foam.
3 Slide the buckle retainer into
the front buckle slot and slide
into the corresponding buckle
position. Ensure the red release
button faces out. Replace
cover.
Child Seat Functions
ADJUSTMENT
SLOT
13