Safety Precautions; Routine User Maintenance - Palazzetti MIRELLA Manual De Instalación Y Mantenimiento

7 SAFETY PRECAUTIONS

Before performing any maintenance operations, adopt the following precautions:
- Make sure that all the parts of the stove have cooled down.
- Make sure that the ash is completely extinguished.
- Make sure that the main power switch is off.
- Make sure that the power supply cannot be reconnected accidentally. Unplug the cord from the socket on
the wall.
- Always use suitable tools for maintenance.
- Once maintenance or repairs have been completed, before operating the stove again, restore all protection
features and reactivate all safety devices.
A suitable ash vacuum cleaner (canister) makes it simpler to clean the ash.
7.1

ROUTINE USER MAINTENANCE

7.1.1
at all times.
Clean the stove only when it's off and has cooled down.
Some models of stove come with a separate handle for opening the door. Take the handle from the ash bin
housing, place it in the holes on the door hinge and lever the mechanism to open the door (Fig.12.1).
7.1.2 Daily cleaning
Lift, remove the burn pot and clean the surfaces and the compartments inside the burn pot (Fig.12.3).
7.1.3 Cleaning the ash bin
The ash bin should be cleaned every week or whenever necessary.
To access the ash bin, open the ash bin door (where foreseen) and remove the bin (Fig.12.4) using the tool
provided
Empty the bin into a special metal ash collection container.
Vacuum any residual ash from the compartment that houses the ash bin.
Reposition and close the ash bin. Close the doors.
7.1.4
Only for models equipped with turbolators:
• Take out the lever for moving the turbulators and removing the soot.
• Insert this into the special notch and move it up and down to remove the soot deposits from the tubes.
• Remove the lever and put it back in its original place.
Carefully close the compartment door again.
An accurate clearing of heat exchanger smoke ducts has to be done at least one time before the heating season
from authorized service.
7.1.5 Cleaning the glass
This is done using a damp cloth or moistened paper passed through the ash.
Rub until the glass is clean. Detergents suitable for cleaning kitchen ovens can also be used.
Never clean the glass while the stove is operating and never use abrasive sponges.
Do not wet the door gasket as this may be damaged (Fig. 12.6).
INSTALLATION
00 477 6270 - 02/2018
37