Little Wave - Flip Under Footrest (Optional) - Ki Mobility Rogue ALX Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
X. Little Wave - Flip Under Footrest (Optional)
To adjust the angle of the footplates:
a. Loosen, but do not remove, the two M6 screws securing the footplate to the footplate
clamp (A) with a 4mm Allen wrench.
b. Once loose, the footplate will rotate around the footrest extension tube.
c. Select desired position and retighten the two M6 screws to 80 in/lbs.
To change the position of the optional angle adjustable footplates:
a. Remove both M6 screws from the footplate. There are M6 nylock nuts recessed on the
underside of the clamp. Be sure to prevent these from falling as you loosen the screws.
b. Relocate the footplate and insert the screws into the appropriate holes.
c. Fit the nuts into the slot underneath the clamp and tighten the screws.
To change the height of the footplate:
a. Slightly loosen both M8 screws from the footplate clamp. Keep the clamp snug so that the
assembly holds together. Repeat on other side of the wheelchair.
b. The entire footplate assembly will slide up and down on the frame.
c. After locating desired position, tighten one M8 screw slightly on each side. Once secure,
finish tightening the four M8 screws. Turn each screw a little at a time to prevent the clamp
from clamping down unevenly.
Tightening the screws unevenly may result in damage to the threads inside the clamp.
A
Fig. 33
38
Fig. 34