Kapro PROLASER 875 GREEN Manual Del Usuario página 13

Working in Pulse mode with a detector:
For outdoor work under direct sunlight, or bright conditions and for
extended indoor ranges up to 60 meters, use the pulse mode with
a Detector.
When the pulse mode is activated the laser beams will flash at a
very high frequency (Invisible to the human eye) this will allow
the detector to detect the laser beams.
1. The pulse mode can be activated in Automatic and Manual
modes.
2. To switch on the Pulse Mode press the push button P (#4), the
green LED (#6) near the P(#4) push button will light up.
3. When the pulse mode is switched on, the visibility of the laser
beams are reduced a little bit.
4. To switch off the Pulse Mode press the push button P (#4)
again, the green LED (#6)near the P (#4) push button will go off.
13