Teka VT TC 2P.1 Instrucciones Para La Instalación página 61

720
INSTALLATION WITH
UNDER THE HOB
The oven should be installed
according to the corresponding manual.
An opening of 20 mm should be made in
the back part of the cabinet in order to
allow cold air to enter (see figure 1).
When hobs are handled before
being installed, care should be taken in
case there is any protruding part or
sharp edge which could cause injury.
When installing units or applian-
570
1175
FAN OVEN ces above the hob, the hob should be
protected by a board so that the glass
cannot be damaged by accidental
blows or heavy weights.
the kitchen unit and in the adhesive on
the decorative laminate of the worktop
surface should be made to tolerate tem-
peratures of up to 100ºC.
for any malfunction or damage caused
by faulty installation.
PLEASE REMEMBER THAT THE GUA-
875
1025
Cut out dimensions for different
combinations of modules
The glues used in manufacturing
TEKA assumes no responsibility
fig. 2
GB
61