Publicidad
Idiomas disponibles
Idiomas disponibles
3. ASSEMBLING THE BAR AND LINES
Chicken Finger & Stopper
How to lock the Chicken Finger into your
harness hook:
The Control System is designed with a Chicken Finger to help you stay
locked into your QRTL. Before you connect the finger to your harness
hook make sure that your lines are set up properly without any
tangles or twists.
1-
Push the finger into the center of the harness hook.
2-
Make sure that it is below the trim loop and that the Chicken Finger
gets all the way in and is straight.
If you want to disconnect from the trim loop, you can grab the finger
and pull it out of the harness hook, and then unhook the loop. Or, you can
release your QRTL as described on page 12.
Rotating Chicken Finger:
Be aware that using this item can cause serious injury or death. When
the chicken finger is installed, you will have to activate your Quick Re-
lease Trim Loop in order to release yourself from the kite. Only use the
chicken finger if you are an expert kiteboarder. Install the chicken finger
only when you are in the water and away from all obstacles. NEVER
return to the shore with your chicken finger installed. To use it simply
slip it under you harness bar hook and out the end so that the QRTL will
not fall from the hook if there is no pressure on the QRTL.
Note:
Pressure from the QRTL can cause the chicken finger to bend and
let the QRTL come unhooked in some circumstances.
Adjusting the power of your kite with the
smart loop:
• To depower your kite pull down on the trim line, below the QRTL, the
desired amount, then lock the line in the jam cleat.
• To give your kite more power, pull down on the trim line to release it
from the jam cleat.Feed out the desired amount of line and then lock
the line back into the jam cleat.
10
naishkites.com
1
2
Trim Line
Publicidad
