Using The Recharge/Emergency Cables; Unauthorised Use - SICE A 926 Manual De Instrucciones

4. In the "Reference Reset" "D" Figure 53, the identification data (Day, month, year,
time) about when the "Save Data" procedure selected to be restored is performed
are indicated.
5. Press "F5" to confirm.
The "Want to continue?" message will be displayed.
I. Press "F3" if you want to reset data filed
Il. Press "F2" if you do not want to reset data filed.
Once the reset data filed procedure is complete, the program will indicate that it is not
necessary to restart to allow the software to reorganise the data just reset.
6. Press "F3"
7. Press "F2" to exit the "Reset Data" screen and go back to the "service" screen.
8. Press "F2" to exit the "service" screen and go back to the starting screen (Logo screen)
9. Press "F10" to switching off the computer.
10. Press "F2" to confirm computer switching off.
11. Switch on the computer
Wait until the aligner program finishes data reorganization before operating.

USING THE RECHARGE/EMERGENCY CABLES

The emergency cable set consists of four cables, which are each 2 m.
To initiate the battery charging process, connect the charge connector for each sensor head (2, fig.
24) to one of the available sockets on the electrical connector panel (A, fig. 3).
The emergency cables allow the operator to continue working even when the measuring head
batteries are flat, in the event of a radio system malfunction or when the calibration procedure is in
progress.
Four RJ45 standard cables of appropriate length are required (not included).
It is forbidden to use the aligner for any purpose other than measuring the characteristic
alignment angles of a vehicle (see description in the chapter "Characteristic Angles").
Use of the aligner for any purpose other than its original function releases the
manufacturer from all responsibility for any damage or injury that may result.
It is recommended to use the Personal Computer installed in the central unit only with the
programs supplied by the Manufacturer.
The software in the HARD DISK and in the update CD ROMs are the property of
Manufacturer and can be used only with the personal computer supplied with the machine.

UNAUTHORISED USE

WARNING
ATTENTION
ATTENTION
51