Steering Window - SICE A 926 Manual De Instrucciones

To switch from step-by-step viewing mode to selection of an angle video clip for display, use the
"Tab" or "Shift" + "Tab" keys.
The following keys are active in this screen:
- F1 displays the on-line "Help" function
- F2 (or "Esc"): halts playback of the clip or returns to the previous screen
- F3 (or "Enter"): starts or replays the clip
- F5 Scrolls down through the adjustment selection list /moves on one step in display of the
clip for an adjustment.
- F6 Scrolls up through the adjustment selection list /moves back one step in display of the
clip for an adjustment.
- F10 returns to the starting window.
For executing the steering for calculating: caster, king pin inclination, included angle, toe-out on
turn (fig. 31).
If turntables with graduated scales are fitted, maximum steering can also be measured visually
and the reading performed can be entered in a suitable window using the keyboard. Admitted
values range from 21.00° to 99.99°; if a value out of that range is entered, the program changes
the entered value to the lowest admitted value (21.00°).
The following keys are active in this window:
- F1 invokes on-line "Help"
- F2 returns to the previous screen
- F3 advances to the next screen
- F4 sets up:
 Unit of measurement
Angles

Grades
Degrees
 Wheel aligner
turntables enabled;

Always;
On request;
Never;
Yes, steering box check;
- F5 sets the maximum steering procedure enabling/disabling (this key is not visible if the
"Turntable enabling" field in the setup is set to "Never").
- F8 displays a window with a list of working windows. Used for skipping quickly between windows.
- F10 returns to the starting window.
To perform the standard steering procedure, follow the on-screen instructions and proceed as
described below:
• release the turntables;
• align the wheels by following the on-screen indicator until "STOP" is displayed;
Note: if the vehicle on which the measurements are being made has very low front and rear
spoilers, preventing the measuring heads' transverse goniometers from making a reading, the
software will display a warning message prompting use of the spoiler procedure, and the
program will continue from the spoiler procedure selection window.
• lock all measuring heads perfectly level;
• turn the wheels to the left until the "STOP" message appears;

STEERING WINDOW

36