Oven Door; Lift-Off Oven Door; Probe - GE PT920 Manual Del Propietário

Care and Cleaning of the Oven
Do not rub or clean the door gasket—
it has an extremely low resistance to
abrasion.
If you notice the gasket becoming worn,
frayed or damaged in any way or if it has
become displaced on the door, you should
have it replaced.
Slot
Hinge lock
Pull hinge locks down to unlock
Removal position
38
Cleaning the Oven Door
To clean the inside of the door:
s
Because the area inside the gasket
is cleaned during the self-clean cycle,
you do not need to clean this area
by hand.
s
The area outside the gasket and
the door liner can be cleaned with a
soap-filled or plastic scouring pad,
hot water and detergent. Rinse well
with a vinegar and water solution.
To clean the outside of the door:
s
Use soap and water to thoroughly
clean the top, sides and front of the
oven door. Rinse well. You may also
use a glass cleaner to clean the glass

Lift-Off Oven Door

The door is very heavy. Be careful when
removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Pull the hinge locks down toward
the door frame, to the unlocked
position. A tool, such as a small flat-
blade screwdriver, may be required.
Firmly grasp both sides of the door
at the top.
Close door to the door removal
position (see illustration).
Lift door up and out until the hinge
arm is clear of the slot.
To replace the door:
Firmly grasp both sides of the door
at the top.

Probe

The temperature probe may be cleaned
with soap and water or a soap-filled
scouring pad. Cool the temperature
probe before cleaning. Scour stubborn
spots with a soap-filled scouring pad,
rinse and dry.
on the outside of the door. Do not let
water drip into the vent openings.
s
If any stain on the door vent trim is
persistent, use a soft abrasive cleaner
and a sponge-scrubber for best results.
s
Spillage of marinades, fruit juices,
tomato sauces and basting materials
containing acids may cause
discoloration and should be wiped
up immediately. When surface is cool,
clean and rinse.
s
Do not use oven cleaners, cleaning
powders or harsh abrasives on the
outside of the door.
With the
Bottom
door at the
edge
same angle as
of slot
the removal
position, seat the
indentation of
the hinge arm
into the bottom
edge of the hinge slot. The notch in
the hinge arm must be fully seated
into the bottom of the slot.
Fully open the door. If the door will
not fully open, the indentation is
not seated correctly in the bottom
edge of the slot.
Push the hinge locks up against the
front frame of the oven cavity, to the
locked position.
Hinge
arm
Hinge
lock
Push hinge locks up to lock
Close the oven door.
s
Do not immerse the temperature probe
in water.
s
Do not store the temperature probe in
the oven.
Hinge arm
Indentation