Rotex GW-30 H12 Instrucciones De Instalación página 89

input
d Minimum rpm hot water
E Min. flow temperature at OT (OpenTherm)
or RF thermostat
E. Reaction OT and RF room thermostat
F Start rpm CH
F. Start rpm hot water
h Max. rpm fan (* 100 rpm)
L Legionella prevention
n Regulated flow temperature during boiler
operation (Ta)
n. Keep hot water temperature at Comfort/Eco
O. Delay time CH request response
o Delay time CH operation after hot water
operation
o. Number of eco days
P Anti-recycling time during CH operation
P. Reference value hot water
q Summer mode
r Heating curve coefficient
Other values : Min. capacity modulating pump.
30 30 Settings reach 20 – 50%
40 40 Settings reach 10 – 60°C
1 1 0= do not respond to CH request if requested temperature is
lower than the set value par. E
1= respond to CH request with minimum flow water
temperature limited to set value par. E
2= respond to CH request with maximum flow temperature as
set in the display (on/off function)
70 70 Settings reach 40 - 99% of the set maximum rpm
70 70 Settings reach 40 - 99% of the set maximum rpm
45 46 Setting reach 40 – 50
This parameter can be used to set the maximum rpm
0 0 0 = not active
1 = legionella prevention once per week
2 = legionella prevention day to day
80 80 Setting reach 60°C - 90°C
0 0 Setting reach: 0 or 40°C – 60°C
0= reheating temperature is equal to hot water temperature
Not applicable for heating only boilers
0 0 Settings reach 0 – 15 minutes
0 0 Settings reach 0 – 15 minutes
3 3 Settings reach 0, 1 to 10.
Not applicable for heating only boilers.
5 5 Minimum switch off time on CH operation
Can be set to 0 - 15 minutes
0 0 Setting reach : 0, 24, 30, 36
Not applicable for heating only boilers.
0 0 0 = Summer mode deactivated
1 = Summer mode to be activated by
(code in display : Su)
2 = Summer mode to be activated by
(code in display : So)
3 = Summer mode to be activated by
(code in display : Et)
0 0 Not active
button
button
button
39