Stel HI-MIG 353/503S-P 400V 3F Manual De Instrucciones página 50

ENGLISH
HI-MIG 353/503S-P 400V 3F
TECHNICAL DESCRIPTION
COD. 6907900030
provided.
g) Connect the gas cylinder (Argon) to the special coupling on the rear panel of the
generator using the setting-up kit provided.
h) Place the bobbin of wire on the reel provided.
i) Open the wire feed compartment and thread the wire through the feeding rollers.
l) Insert the plug in a power socket complying with the regulations in force.
m) Switch on the machine, turning the switch on the rear panel to position "1". Switch on
also the cooling unit AWC, if fitted.
When the generator is switched on, all the signals will be displayed for about 2 seconds;
then the displays (ref.5-7 page 9) will show the type of welding selected for 2 seconds.
Regulating the MIG 2T welding parameters: manual regulation
1) Press the SELECT MODE button (ref.29 page 9) until the MIG 2T mode led (ref.32 page
9) lights up.
2) The letters MIG 2t will appear on the displays (ref.5-7 page 9) for 2 seconds.
3) Regulating the wire speed from the generator – Press the A/ wire speed button (ref.25
page 9) until the led A (ref.4 page 9) goes out. The A/wire speed encoder (ref.6 page 9)
may be used to set the wire advance speed from 1.4 to 16 metres per minute, shown on the
left-hand display (ref.5 page 9).
3a) Regulating the wire speed from the wire feeder – The A/wire speed potentiometer
(ref.41 page 10) is used to regulate the wire speed following the scale indications or
checking its value on the left-hand display of the generator (ref.5 page 9).
4) Regulating the welding voltage from the generator – The V/SET potentiometer (ref.8
page 9) is used to regulate the welding voltage, the value of which is shown on the right-
hand display of the generator (ref.7 page 9).
4a) Regulating the welding voltage from the wire feeder – The potentiometer V (ref.42 page
10) is used to set the welding voltage following the scale indications or checking its value on
the right-hand display of the generator (ref.7 page 9).
As regards the regulations from the generator or from the wire feeder, the last regulations
made will remain operative also at the time of restarting the machine.
5) Regulating the ARC TRIM Electronic Inductance. – Pressing in sequence the SET button
(ref.10 page 9) selects the ARC TRIM electronic inductance function led (ref.16 page 9).
The right-hand display (ref.7 page 9) will start to blink, indicating the letters At; with the V/
SET encoder (ref.8 page 9) you can regulate the value from –40 to +40%
To view the set value at any time, briefly press the SET button.
The ARC TRIM function allows you to vary the dynamic characteristics of the welding arc: to
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it
50