Troubleshooting - Suntec Wellness Klimatronic Impuls plus Manual De Instrucciones


As soon as the water tank is full, the "WF" blinks on the display, the standby mode automatically turns
on, it will sound the warning alarm and all the buttons will be locked until the tank is emptied.

To empty of the water tank you need to remove the rubber stopper on the bottom of the unit and let the
water leak into a container.

Turn off the power and unplug the power cord. Once you reboot the device, it will work normally.
Cleaning
Before starting cleaning or maintenance, turn the power off by pressing the POWER button, wait a few minutes
and then unplug the power cord from the outlet.
Surface cleaning
Clean the unit using a damp cloth, and then wipe it using a dry cloth. Do not use chemical solvents (such as
gasoline, alcohol). The surface and the entire housing could be damaged.
Air filter cleaning
Clean the air filter regularly. If the air filter is clogged with dust, the efficiency of the device could be
reduced.
1) Open the air outlet and remove the filter.
2) Wash the air filter by submersion into warm water (about 40° C) with neutral detergent, rinse it under
running water and dry it with a soft cloth.
3) Install air filter carefully after cleaning and drying.
Storage
1. Pull the power plug and empty the water tank. Then set the device into the operating mode. Press the fan
button and hold it for a. 5 seconds until the device switches to low fan speed. Let the unit run in this mode for half
a day until the inner construction has dried. Thus, it will not become mouldy.
2. Turn off the unit and unplug the power cord.
3. Coil the cord and attach it to the holder.
4. Disconnect the exhaust tubing from the device and keep it safe.
5. Put the unit into a box and bring it to a dry place.
6. Remove the batteries from the remote control and keep them safe as well.

Troubleshooting

Don't repair or disassemble the unit by yourself, unsuitable repair may make the quality-protected card in vain,
and even cause damage to the user or his/her possession.
Problems
1. The unit does not
turn on when you
press the Power
button.
2. The unit restarts
again and again
3. Noise
4. Compressor does
not start
Spare parts and accessories supply (fast convenient supply)
You can obtain spare parts and accessories for your IMPULS unit from your local dealer. And at our website
you will find further information on individual accessory products as well as information on obtaining our spare
parts quickly and conveniently. You will also find other information (e.g. FAQ, lists of spare parts, document
download, etc) about your MOVE unit.
Cause
Power cord is not plugged.
Water full indicator lamp blinks.
Windows and doors are open, other
heat sources in the room (leading to
temperature variation)
Direct sunlight
Exhaust hose is disconnected or
blocked.
Air inlet is blocked by smth.
The unit does not stand on a flat
surface.
Thermal protection function is
activated.
www.suntec-wellness.de
Solution
Insert the plug into the socket and turn on the unit.
Empty the water tank.
Close doors and windows, remove the heat source.
Put the unit to the shade or draw the curtains.
Connect or clean exhaust hose.
Clean the blocked place.
Place the unit on a hard flat surface (reduces noise).
Please turn off the device and restart it 30 minutes
later.
18