4.4 Attaching The Cable Gland - Minebea Intec PR 6021/08 Manual De Instalación

4 Installation and connection information

4.4 Attaching the cable gland

Minebea Intec
1. Remove the parts from the packaging.
2. Slide the sealing ring (3) over the thread of the cable gland (2).
3. Screw the cable gland (2) into the cable junction box and tighten at the hex.
Note:
It is essential that the following tightening torques are observed:
M20: 4 Nm
M25: 6 Nm
4. Screw the cap nut (1) onto the cable gland and tighten slightly.
Weighbridge Cable Junction Box PR 6021/08
EN-13