Connect To Your Network Using Wps (If Your Router Supports It) - Wren V3US Guía De Inicio

Connect to your network using WPS (if your router supports it)

WiFi Protected Setup (WPS)
WiFi Protected Setup (WPS) is a feature on some WiFi routers that allows the Wren V3US
speaker to automatically and securely connect without needing to enter a password. WPS is
not a standard feature on all routers, and only one Wren V3US speaker can be set up at a time.
Check your router's owner manual to see if WPS is a feature, or look for a button on your
router marked with the WPS logo . If your router does not have WPS, then use the
method appropriate to your device. (See the Index on page 9 to locate setup instructions
for your device.)
If your router has WPS, use the following instructions.
Plug in the Wren V3US speaker near
your router. Wait approximately
10 seconds for the speaker to fully
power on (when the power indicator
light stops blinking).
solid white
32
Press and hold the setup button on
the rear of the product for three
seconds, then release. The WiFi
indicator will blink amber two times,
then pause every second. The speaker
is now in WPS Mode.
blinking
amber
Place your router in WPS Mode.
Usually this is done by holding the
router's WPS button, but check
your router owner's manual.
Problem connecting? Visit wrensound.com/support for additional help.
When the secure connection is made,
the WiFi indicator on your Wren V3US
will stop blinking and remain solid white.
solid
white
How To Exit WPS Mode
If during the setup process you need
to exit the WPS Setup Mode, press the
Source button once. The speaker will
then return to its previous mode.
amber
33