To Start A Warm Engine - Husqvarna 120 Mark II Manual Del Usuario

2. Push the primer bulb 6 times.
3. Move the choke control to the full choke position.
654 - 002 - 12.04.2018
4. Hold the body of the product on the ground with
your left hand. Put your right foot in the rear
handle to make the chainsaw stable. Pull the
starter rope handle slowly until you feel some
resistance. Then pull the starter rope handle with
force 5 times.
Note: Do not pull the trigger while you start the
engine.
5. Move the choke control to the no choke position.
6. Pull the starter rope handle until the engine
starts. Wait 60 seconds after a start before you
pull the trigger.
CAUTION: Do not pull the starter
rope until it stops. Do not let go of the
starter rope when it is fully extended.
Release the starter rope slowly.
Obey these instructions to prevent
damage to the engine.
7. Pull the front hand guard in the direction of the
front handle to disengage the chain brake.
8. Hold the rear handle with your right hand and the
front handle with your left hand.
9. Use the product.

To start a warm engine

1. Move the front hand guard forward to engage the
chain brake.
2. Push the primer bulb 6 times.
3. Move the choke control to the full choke position.
4. Move the choke control to the no choke position.
5. Hold the body of the product on the ground with
your left hand. Put your right foot in the rear
handle to make the chainsaw stable.. Pull the
starter rope handle slowly until you feel some
resistance. Then pull the starter rope handle with
force until the engine starts.
13