V2 CALYPSO 400 Manual De Instrucciones página 17

ACTUATOR FIXING
Choose measures referring to the table you can find in
the previous page, mark them on the pillars and
continue as follows:
• Fix the clamps to the pillar and to the gate soldering
directly; if the material does not allow it, it is
necessary to solder the clamps to plates to be fixed to
the gate and the pillars by screws.
• Close the swing.
• Unlock the actuators.
• Position CALYPSO on the brackets and fix the pins
no. 1 and no. 2 with seeger (see the picture).
• Open and close the swings repeatedly manually to
verify the absence of frictions between gate and
ground.
WARNING: in order to avoid damage to the
actuator, please adhere to the following conditions:
• The brackets must be installed at the same height.
• The maximum stroke of arm A should not exceed
456 mm for CALYPSO400 and 556 mm for
CALYPSO500 (in case of gate completely closed).
• The minimum stroke of arm B must be more than
56 mm (in case of gate completely open).
15