Hilti PS 200 S Manual Del Usuario página 47

All manuals and user guides at all-guides.com
This screen appears on the scanner and a beep sounds:
Press the Confirm button on the scanner to begin importing all scan data into the selected project.
This screen appears on the scanner while data transfer is in progress and the red LED on the scanner flashes
continuously.
Data transfer takes between 1 and 15 seconds, depend-
ing on the number and length of scans contained in the
scanner.
This screen is displayed by the scanner when data transfer is complete:
Press the Confirm button on the scanner again to end the
data transfer procedure. The scan data in the scanner is
then deleted automatically.
5.16.2 Data transfer between the scanner and the adapter
Note
Use the adapter only indoors. Avoid moisture ingress.
Note
Ensure that the windows at the infrared ports are free from dirt, dust and grease and are not excessively
scratched before commencing data transfer. Failure to do so may result in reduced transfer range or
may prevent the data being transferred.
Data is transferred from the scanner to the adapter using the infrared connection. The infrared windows are
situated at the ends of scanner and the adapter.
Note
The maximum range of the infrared connection is approximately 30 cm (12 inches). The maximum
permissible angle between the scanner and adapter for successful data transmission at close ranges
(up to 10 cm (3.94")) is ± 50° relative to the axis of the infrared port on the adapter. At a distance of
15 cm this angle is reduced to ± 30°. At a distance of 30 cm (11.81") the scanner must be accurately
aligned with the adapter to ensure successful data transmission. Scans can be transferred at any time
when the scanner and adapter are switched on and the scanner is displaying the main menu.
Bring the scanner and adapter close together so that the infrared windows are facing each other. The two
devices recognize each other automatically and establish a connection. The following screen appears on the
scanner and a beep sounds:
Press the Confirm button on the scanner to begin data
transfer. The following may be observed while data
transfer is in progress:
The green LED on the adapter flashes rapidly to indicate that data transfer is in progress. The red LED on
the scanner flashes continuously:
This screen is displayed by the scanner when data transfer is complete:
Printed: 14.11.2016 | Doc-Nr: PUB / 5314765 / 000 / 00
English 43