Using The Remote Control Unit; Operation; Before Operating; Remote Control Unit (Rc-907) - Denon DRA-295 Instrucciones De Operación

7 USING THE REMOTE CONTROL UNIT

Following the procedure outlined below, insert the batteries before using the remote control unit.
Range of operation of the remote control unit
B
30°
30°
Approx. 7 m
Inserting the batteries
q Press as shown by the arrow w Insert the R6P/AA batteries properly,
and slide off. as shown on the diagram.
NOTES:
• Use only R6P/AA batteries for replacement.
• Be sure the polarities are correct. (See the illustration inside the battery compartment.)
• Remove the batteries if the remote control transmitter will not be used for an extended period of time.
• If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact
with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.
• Have replacement batteries on hand so that the old batteries can be replaced as quickly as possible when the
time comes.
• Even if less than a year has passed, replace the batteries with new ones if the set does not operate even when
the remote control unit is operated nearby the set. (The included battery is only for verifying operation.
Replace it with a new battery as soon as possible.)
All manuals and user guides at all-guides.com
Point the remote control unit at the remote control
sensor as shown on the diagram at the left.
NOTES:
• The remote control unit can be used from a straight
distance of approximately 7 meters, but this distance
will shorten or operation will become difficult if there
are obstacles between the remote control unit and
the remote control sensor, if the remote control
sensor is exposed to direct sunlight or other strong
light, or if operated from an angle.
• Neon signs or other devices emitting pulse-type noise
nearby may result in malfunction, so keep the set as
far away from such devices as possible.
e Close the lid.

8 OPERATION

Before operating

B
1 1 2 1
1
OFF POWER ON
RANDOM DISC SKIP ＋ 8 9
CD
REPEAT 3 2 1
A / B 4 REC 3 2
TAPE
6 7 0 1
TUNER CD CDR DVD / VDP
SHIFT TAPE AUX
2
• •
DIMMER A
PRESET STATUS SPEAKER MASTER VOL
ª B ª
MUTING
B
REMOTE CONTROL UNIT RC-907
ENGLISH
Preparations:
Check that all connections are proper.
1
Turn on the power.
Press the power operation switch (button).
OFF POWER ON
(Main unit) (Remote control unit)
• ¢ ON/STANDBY
The power turns on and power indicator is lit.
Several seconds are required from the time
the power operation switch is set to the "¢
ON/STANDBY" position until sound is output.
This is due to the built-in muting circuit that
prevents noise when the power switch is turned
on and off.
Set the power operation switch to this position
to turn the power on and off from the included
remote control unit.
• £ OFF
The power turns off and power indicator is off.
In this position, the power cannot be turned on
and off from the remote control unit.
2 Select the speakers.
Press the SPEAKER A or B button turn the speaker
on.
SPEAKER A
A B
SPEAKER
B
(Main unit) (Remote control unit)
7