Cub Cadet 17BIDGHB603 Instrucciones De Funcionamiento Originales página 15

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 112
Assembly
Attaching the seat
Remove the screws and nuts on the seat
holder .
Fix the seat support to the seat holder
the previously removed screws and nuts.
Note
When mounting the seat do not damage
the cable of the seat switch! Surplus cable
segments must be pushed back into the
opening of the seat holder.
Fold the seat down
Attaching the trailer coupling (optional;
depending on the model)
Remove the trailer coupling [1] with the screws [2]
and nuts [3] on the rear panel [4] of the device
Rotate the trailer coupling horizontally by 180°.
Fix the trailer coupling [1] with the screws [2] and
the nuts [3] to the rear panel [4] of the device
Putting the battery into operation
DANGER !
caused by battery acid and gases emitted
by battery acid
Battery acid is corrosive. Immediately
clean all parts of the device splashed by
battery acid.
Do not smoke; keep burning and hot
objects away.
Charge batteries in a well ventilated and
dry room only.
There is a risk of a possible short circuit
when working with the battery. Do not
place any tools or metal objects on the
battery.
769-10224B
using
.
Risk of poisoning and injury from battery
acid
Wear safety goggles and protective
gloves.
Do not allow battery acid to come into
contact with skin.
If battery acid is sprayed in your face or
eyes, wash it off immediately with cold
water and seek medical attention.
If you have swallowed battery acid, drink
a lot of water and seek medical attention.
Store batteries out of the reach of
children.
Never tilt the battery, as battery acid may
run out.
Bring the remaining, unused battery acid
to your dealer or to a waste disposal
company.
.
Disconnect and connect the battery in the correct
sequence.
Only operate the battery with the battery terminal
.
protective battery cover).
Note
The battery is situated under the passenger
seat.
the factory.
Installation
First connect the red cable (+ / positive ter-
minal)
.
Then connect the black cable
(- / negative terminal)
Attach the battery terminal cover.
Removal
Remove the battery terminal cover.
First disconnect the black cable (- / negative
terminal).
Then disconnect the red cable (+ / positive ter-
minal).
DANGER !
Attention !
.
EN
15

Publicidad

Tabla de contenido
loading

Tabla de contenido