Storage - Cub Cadet 17BIDGHB603 Instrucciones De Funcionamiento Originales

Storage

Disassembly
Park the device on an even surface and switch the
parking brake on.
Bring the wheels of the cutter deck into the
highest position.
Lower the cutting mechanism and bring it into the
lowest position.
Put the locking pin from outside right into the
position " " (above the cutting height adjustment
lever) and turn them down to secure them.
This secures the cutting height adjustment lever
located under the locking pin.
Remove the V-belt
(engine belt pulley)
or right side of the V-belt backwards and then
downwards while manually turning the engine belt
pulley in the opposite direction.
Note
Pull out the splint left and right cutter deck sus-
pension [C] [A] to separate the cutter deck
from the suspension unit. In doing so, support
ground.
Push the cutter deck forwards to separate it from
the front suspension unit
Place the cutting height adjustment lever upwards
into the highest mowing position.
Insert the locking pin into the highest mowing
position and let the cutting height adjustment lever
above it latch in on the locking pin.
Pull out the cutters from beneath the device.
Assembly
To reinstall the cutter deck, perform the steps in
the "Disassembly" section in reverse order.
Note
Following assembly, check that the V-belt is
positioned correctly and is not twisted
Park the device on an even surface and switch the
parking brake on.
Note
Before aligning the cutters check the tyre
pressure on the device.
When mowing does not appear to be parallel to the
lawn the cutters can be aligned.
769-10224B
[A] from the PTO coupling
[B]. To do this, pull left
[B].
Setting the cutter deck side level
Bring the cutter deck to the middle height position.
Carefully turn the outer cutters transverse to the
drive direction.
Measure the distance between the ground and the
ends of the two outer cutters.
The distance should be equal at all times. If
necessary, you can set the correct level as
follows. Perform the adjustment on the adjustment
segment [1] of the cutter deck:
Release the locknuts [2].
To set the level, turn the adjusting nuts [3].
Re-tighten the locknuts.
Set the cutter deck level from front to
back
Note
First check the side cutter deck level.
Park the device on an even surface and switch the
parking brake on.
Bring the cutter deck to the middle height position.
Carefully turn the outer cutters parallel to the drive
direction.
Measure the distance between the ground and the
end of the right cutter.
The end of the front blade should be about 6-9 mm
lower than the rear. You may have to adjust the front
[1] as follows:
Release both nuts [3] turning them in an anti-
clockwise direction.
To set the level, turn both adjusting nuts [2]
equally.
Tighten both nuts [3].
Damage to appliance materials
Store the device in a clean, dry enclosed space.
.
Protect the device from rust when storing it for
lengthy periods of time.
Protect the device from frost.
Clean the device and the grass catcher.
Wipe all metal parts down with an oily cloth or
spray them with oil to protect them from rust.
Charge the battery.
Remove the battery in the event of long-term
storage (e.g. over winter).
Charge up the battery every 6–8 weeks in the
event of long-term storage and before reinstalling.
Drain the fuel and shut down the engine – see the
engine manual.
Check the tyre pressure.
Storage
Attention !
EN
25