Publicidad
Idiomas disponibles
Idiomas disponibles
9. Movethrottle leverto"Fast"position, shown here
asa rabbit.
10.Movechoke leverto"Choke"position.
NOTE: F ora warmengine, b esurethechokeleveris
in the"Run"position.
11.Grasp handle andpullrecoil s tarter l ightlyuntilyou
feelsomeresistance, thenpullbriskly.
wAR.a.G
]
When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
If engine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze
trigger on spray gun.
2. Return
recoil starter slowly.
DO NOT let rope
"snap back" against
starter.
13. When engine
starts, slowly
move choke
lever to
"Run"
position
as engine
warms,
if engine
falters,
move
choke lever to "Choke"
position,
then to
"Run"
position.
14. if engine
fires,
but does not continue
to run,
squeeze
trigger on spray
gun to relieve
internal
pump pressure.
Move choke
lever to "Run"
position,
and repeat steps
11 through
13.
IMPORTANT:
If engine
floods,
place choke
lever in
"Run"
position
and crank until engine
starts.
NOTE:
Always
keep the throttle
lever in the "Fast"
oosition
when operating
the pressure
washer.
DO NOT touch hot surfaces.
Allow equipment
to cool before touching.
The pressure washer
must be at least 5 feet from structures
having combustible
walls and/or other combustible
materials.
Keep at least 3 feet of clearance
on all sides of pressure
washer
for adequate
cooling, maintenance
and servicing.
In the State of California
a spark attester
is required by law
(Section 4442 of the California
Public Resources
Code). Other
states may have similar laws. Federal laws apply on federal
lands, if you equip the muffler with a spark attester,
it must be
maintained
in effective working order.
How to Stop Your
C_eaning
System
1.
Let engine idle for two minutes.
2.
Move throttle lever on engine to "Stop" position.
CAUTION
DO NOT stop engine
by moving
choke
lever to "Choke"
position.
Backfire,
fire or engine
damage
could occur.
3.
Squeeze trigger
on spray gun to relieve
trapped
pressure
in hose to avoid injury.
NOTE: A small amount of water will squirt out when
3ressure is released.
WARNING
Keep
high pressure
hose connected
to pump
and spray
gun while
system
is pressurized.
Squeeze
trigger
on spray
gun to relieve
trapped
pressure,
every time you stop engine.
Engage
trigger
lock on spray
gun.
4.
Rotate the Dial-A-Cleaner
TM
selector
knob to
the OFF position
to prevent chemicat
leakage.
5.
Engage trigger lock on spray gun when not in use.
How to Use Accessory
Tray
The unit is equipped with an accessory tray with
places to store your ProjectPro
TM
nozzles, spray gun
and nozzle extension.
NOTE: The extra hole in the tray is for storing a utility
brush. The extra clip in the tray is for storing a turbo
nozzle. The brush and turbo nozzle are NOT included
with your pressure washer. You can buy these items
as optional accessories.
1.
Place nozzle extension through hole on accessory
tray, as shown.
2.
Place spray gun through hole on accessory tray
on right side of unit.
3.
Insert multi=colored ProjectPro
TM
nozzles in
spaces provided in accessory tray.
10
Publicidad
