Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Place cartridge into fuel cap.
2.
Push to "snap" cartridge into place.
3.
Remove tab to expose membrane.
IMPORTANT:
DO NOT remove the silver foil seal on
the opposite side.
4.
Reinstall fuel cap on fuel tank.
.
f
Jr
Periodically check the cartridge to ensure there is
still fuel stabilizer inside, if it is empty, remove
cartridge and replace.
Connect
Hose and Water Supply
to Pump
IMPORTANT:
To avoid pump damage, you must
assemble the nozzle extension to the spray gun and
attach all hoses before you start the engine.
1.
Uncoil high pressure hose and attach one end of
hose to base of spray gun. Tighten by hand.
Inspect inlet
screen. DO NOT
use if damaged;
clean if dirty.
4.
Before connecting garden hose to water inlet,
inspect inlet screen. Clean screen if it contains
debris or have it replaced if damaged. DO NOT
run pressure washer if inlet screen is damaged.
5.
Run water through garden hose for 30 seconds to
flush it of debris. Turn off water.
IMPORTANT:
DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
6.
Connect garden hose (not to exceed 50 feet in
length) to water inlet. Tighten by hand.
CAUTION
.
Damage
to equipment
resulting
from failure
to follow
this
instruction
will void warranty.
Turn ON water and squeeze trigger on spray gun
to purge pump system of air and impurities.
WARNING
Always
wear
eye protection
when
using this equipment
or in vicinity
of where
equipment
is in use.
Before
starting
the pressure
washer,
be sure you are
wearing
adequate
eye protection.
CHECKLIST
BEFORE
STARTING
2.
Remove and discard shipping caps from pump
inlet and outlet.
3.
Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
Review the unit to ensure you have performed all of
the following:
1.
Make sure handle is in place and secure.
2.
Check that oil has been added to proper level in
engine crankcase.
3.
Add proper fuel to fuel tank.
4.
Check for proper hose connections (high pressure
and water supply) and that there are no kinks,
cuts, or damage to the high pressure hose.
5.
Provide proper water supply (not to exceed
100°F).
6.
Be sure to read "Safety Rules" and "Operation"
sections before using the cleaning system.
Publicidad
